PIC18 jump from bootloader to aplication

€8-30 EUR

Avslutat

Publicerad

ungefär fem år sedan

€8-30 EUR

Betalning vid leverans

I have a little bootloader that flash a new firmware into the top memory, when it finish i make Reset() (LINE 197) and aplication runs fine , the problem is when I turn off the circuit, it start again from bootloader I make a eeprom variable set to 1 if flash was sucessfuly, so then if eeprom == 1 I perform a reset() (LINE 79) to force to start aplication but doesn't work PIC18F26K22 made in MPLAB X 4.20, i don't accept another version

C Programming

Electrical Engineering

Electronics

Firmware

Microcontroller

Project ID: 19260715

Om projektet

4 anbud

Distansprojekt

Senaste aktivitet fem år sedan

Ute efter att tjäna lite pengar?

E-postadress

Fördelar med att lägga anbud hos Freelancer

Ange budget och tidsram

Få betalt för ditt arbete

Beskriv ditt förslag

Det är gratis att registrera sig och att lägga anbud på uppdrag

4 frilansar lägger i genomsnitt anbud på €34 EUR för detta uppdrag

@Hafeez143

Hi, I found that in your code at line 198 you are calling GotoAppUser(); after calling Reset(); but this is not done at line 79. Regards, Hafeez

€50 EUR Om 1 dag

4,9

(13 omdömen)

5,9

@gsa5b06f37877085

Hello, I am an electromechanical and electronic technician, and I only have the thesis to be an electronic engineer. I work in an electrical testing laboratory, under international standards, im work here for more than a year ago. I have experience in electronics design. If you want to know something else, do not hesitate to contact me I think it could be of great help for your project. I am already at your disposal. regards

€30 EUR Om 10 dagar

5,0

(2 omdömen)

2,3

@jayanthd2k12

I have 17 years experience with electronics and 8 years of experience in embedded electronics. I have worked with 8051, PIC, AVR, PIC24, dsPIC, PIC32, STM32, Tiva, Stellaris, LPC, MSP430, FT90x, Arduino, ChipKit, RaspBerry Pi controllers. I have all the necessary tools (software, hardware, and test equipment) like Keil, mikroC, mikroBasic, mikroPascal, CodeVisionAVR and much other software. I have many development boards and modules. I have a lot of test equipment to test and debug the codes like Oscilloscope, Logic Analyzer, etc,... I can provide you a working professional code within 1 hour. You can contact me at jayanthd2k12(at)gmail(dot)com In the above replace (at) with @ and (dot) with .

€22 EUR Om 1 dag