Modifying an existing model for a simple gym space and then producing 2 renderings

This job's final product are 2 renderings fairly nice with people and entourage in them. A) I have attached the SKP model of the latest version, but now the SKP model needs to be updated to the plan. This can be done completely in revit as well. B) Once the model is done we'll find a few mockup shots and find the best one. Most of the shots should be from inside the spaces: SHOT 1.) Highlight Cycling Studio (space is 28’ x 41’) – 34 participant bikes + 1 instructor bike. The 34 participant bikes will be spread across three arced rows and three levels (as they were before). First row on ground level, 4 inches up to second row and 4 more inches up to third row. Bike pattern might be 8, 12, 14. You can play with spacing to determine the best arrangement. There will be two 65” monitors in the front of the room. There will be a large window on the South end of the cycling studio (~4’ high x ~18’ in length). The instructor will be situated in at the mid-point of the East wall of the cycling studio. SHOT 2.) Highlight Rowing Setup (space is 24’ x 52’ not including storage area for rowing machines) – The Southwest corner of this training area is rounded off. Please show 24 rowing machines stacked two deep and facing the mirrored wall on the East side of the building. This should give you an outline of what the plan is. Eventually we want to have a couple of nice renderings with all the stuff inside the room and a few people and entourage. Again, the first step should be to generate the basic model and then make some shots so we can chose the best shots for making them look very nice. Please consider: -Since we only want a couple of shots, the material application in revit (or whatever model you are using) only needs to happen in the visible area (which will be determined through the mockup shots.