Firmware development using STM32F407

Hi there, I have almost 13 years of experience. I have read the details and have a few questions. Please get back to me to discuss it further. Waiting for your reponse Thanks.

Hi, I hope you are doing fine. I am an expert in C programming, Microcontroller (AVR, ARM and etc), Arduino and Python.I have done some simulation and testing various type of Microcontrollers and sensors. I have exper Mer

Are you looking for someone who has very experienced in stm32F407 firmware development? Especially CAN? if Yes, please contact me. I have rich experience in Stm32 and CAN, I built a project using stm32. In the project Mer

I have more than 7 years experience in embedded hardware and firmware development . So I can do your job within a time limit with your satisfaction.

• GPRS(etc) I am specialist in development and interfacing between Android application and arduino board. hardware designing for embedded hardware. software development for embedded hardware. Home automation. Mer

Hi, I have expertise in STM32 and embedded systems, CAN,SPI etc. Refer my profile for details. Please send me detailed requirements. Thanks.

Hello, I have 10+ years of Embedded product design with multiple domains like a consumer, industrial, automotive, IOT and wearable product. -Hardware architecture design using MCU, controller, and FPGA, as well as low Mer

Hai sir I read your project details I can support your project end to end feel free to contact me I give a support

I designed firmware and hardware of an OBD device with STM32407 and Siliconlabs' chip BGM121. I think my experince with the OBD project fullfills the requirments of your project and shortenst the project development ti Mer

TSD Techno Services worked on electronics and embedded products and services. Hardware design and development. Firmware design and development. Software design and development. Prototype development. IoT design a Mer

Hello, I am electronics engineering graduate from mumbai university. I have also done embedded system course. I have worked on few embedded projects. I have experience with different microcontrollers and can program in Mer