Read microcontroller MSP430 and copy to newone

Hi! I have understood your requirements about your project with every detail of it. I am an Electrical Engineer with more than 9 years of experience in electronics, circuit design, PCB layout, Verilog, FPGA, Embedded systems, microcontrollers, Proteus, Arduino, ESP32, Raspberry pi, NB-IoT, MATLAB, PLC Design, Algorithm, and Product design. I can assure satisfactory work. I'll be glad to work with you. Thanks

Good day, I have more than 30 years experience in Microcontroller MSP430 designing. I can help to read microcontroller msp430f2132 and program new one in a quality and timely manner. I have seen attached image shared by you and will be able to execute this project. I would like to have a thorough discussion on this project as there are certain suggestions from my side After dedicating more than 30 years to the electronics design and development, I am passionate in designing the best products Technology wise I have worked on all the latest technologies like GSM, 5G, Lora, Microcontroller "m430f2132 etc. And have worked on more than 20 design tools for designing and simulation purpose Some of the generic queries from my side are: 1. What is the application of this product? 2. What will be the ambient temperature of this product? 3. What are the mechanical constraints to be taken care of? If you are someone who wants to benefit from my experience just message me Hi and I shall be there for you. Regards Hari Mohan Engineering for one is magic for others

ok i understood your requirement but I have few doubts, text me so I can clear all my doubts right away, I can help you and i am ready for work. Thank you.

Hi, I am embedded software developer more than 10 years . if you give me a chance, I can help you with your issue as soon as possible.

Hello, I have rich experience in C/C++ programming. I have read all your explanations carefully and fully understand your requirements. So I am sure I can give you correct and good results. I would appreciate it if you could contact me soon and share your project details. we can discuss about timeline and budget on there. Thank you.

I have experience in embedded C. I worked in arm,pic ,atmel, Arduino,microcontroller. Worked on protocol - UART,I2C,I2S,SPI,ADC,DAC,TIMER.

Hi, I worked with microcontrollers like Texas MSP430F2131, Atmel, microchip, and freescalem for more than 20 years. if you give me a chance, I am sure We can finish this work