Nextion display / Arduino Code
$30-250 USD
Betalades vid leverans
Dear Guru
I have a Project I need some Arduino Code written to make it run.
The Project is a Tube Preamp a one off DIY project,
Using a Nextion Touch Screen and a Arduino board to switch the audio Inputs Relays (x10) on and off (E.g. when I touch Audio input 1 on the screen Pin 1 on the Arduino will go HIGH and all the rest will go LOW
I would also have 5 x Analogue inputs x 2 these would read any change in a Volume Pot movement and display the return in a scale from 0 to 20
And display this Volume for a few seconds example Left Gain (Reading Return) with the same for the right side
The 3rd and 4th analogue pins that will display a Lift or Right Clip Text
When a certain audio level is reached on input pin
And lastly a analogue pin to display a ramp up voltage from 2V to 7 volts
I can build the regulator to scale it from 0 to 4.5 V
This would run at the start up for the first 60 seconds
I have the Graphics for the screen but need the serial code
I hope you can help and if you could give me an estimate
(REMOVED BY FREELANCER.COM ADMIN)
Projekt-id: #15530837
About the project
5 frilansare har lagt bud på i genomsnitt $217 för det här jobbet
Hi, I can do audio inputs control from Arduino and Nextion. Regards. Relevant Skills and Experience Arduino Proposed Milestones $250 USD - Project
Hi , I am an electronics engineer and an Arduino expert. I have done similar projects in past and I would like to discuss more about the project. Feel free to send me a message here.
Hello, I am an electronic engineer with a tol of experience in arduino boards. Wirte me for more info about hte project. I am sure I can help you with it. Regards Habilidades y experiencia relevante Electro Mer
