Plastic Astronaut helmet with visor with 3D printable file in STL format

  • Status: Closed
  • Pris: $150
  • Bidrag mottagna: 23
  • Vinnare: makhan22

Tävlingssammandrag

I'm needing to design a plastic Astronaut helmet with a spring loaded mirrored lens visor. It will need a small contained square over the mouth for a voice box to be inserted. The measurements on the voice box to come later.

The visor will cover the entire face, and held down by a latch, and pop open/up with springs so the face fully shows when latch is undone. Attached is a good starting point.

Rekommenderade kompetenser

Arbetsgivares feedback

“Amazing work, creative, and enjoyable to work with. Highly recommend!”

Profilbild adschiel, United States.

Topp bidrag från den här tävlingen

Visa fler bidag

Klargörandetavla

  • adschiel
    Tävlingsinnehavare
    • 5 år sedan

    Hello all, and thank you all for your entries. A winner has been decided and has been notified. Thank you again.

    • 5 år sedan
  • amirfreelancer12
    amirfreelancer12
    • 5 år sedan

    HI , working on it , almost finish , please wait

    • 5 år sedan
  • ahmadnazree
    ahmadnazree
    • 5 år sedan

    Hi CH, please rate #22 . Thank you very much.

    • 5 år sedan
  • prashant8080
    prashant8080
    • 5 år sedan

    If I provide you the update, is there any chances you will respond ? or can guide with a corrections ?
    ( As I have prepared the Entire Model by using your picture as a reference, I feel that there is something still remaining, and that is what I am expecting from you if you can send me the feedback for the same ? )

    • 5 år sedan
    1. adschiel
      Tävlingsinnehavare
      • 5 år sedan

      Yes, I will give feedback for every entry. Thank you for your interest.

      • 5 år sedan
  • adschiel
    Tävlingsinnehavare
    • 5 år sedan

    Thanks for the interest. Size will be for an average size adult head... Not overly snug like a baseball helmet, but loose easy to get on and off... I would like to receive JPG photos displaying the helmet from all sides, and a 3D printable file in STL format.

    • 5 år sedan
  • Vadymykh
    Vadymykh
    • 5 år sedan

    Any information about 1) size 2) dimensions 3) end result? What do you expect to receive? .STL, .STP, .JPG?

    • 5 år sedan

Visa fler kommentarer

Hur du kommer igång med tävlingar

  • Lägg upp din tävling

    Lägg upp din tävling Snabbt och enkelt

  • Få massvis med bidrag

    Få massvis med bidrag Från världens alla hörn

  • Utse det bästa bidraget

    Utse det bästa bidraget Ladda ner filerna - enkelt!

Lägg upp en tävling nu eller gå med idag!